Type A

Used normally with double-sided laminated materials. It can be used for tie drum materials, aerosol metal ring & bottom materials, caps and 18-liter can cover/bottom materials in applications without coating or printing.

• Direct laminating of biaxial oriented polyester film to heated TFS.
• The laminated polyester layer consists of a biaxial oriented later and a non oriented layer.
• single-sided laminated materials are also available.

Type B

Used normally with single-sided laminated materials. It can be used for tie drum materials, aerosol metal ring & bottom materials, caps and 18-liter can cover/bottom materials in applications where coating or printing is required.

• Laminating of biaxial oriented polyester film to heated TFS or tinplate via primer.
• Practical film adhesion obtained from a heating process (190 degree centigrade or higher for 10 minutes) after coating or printing for consumers.
• Double sided lamination also available.

White Film

Laminated white color polyester film replacing normal clear polyester film.

• Type A or B, and single or double sided lamination available.
• Clear film front and back differential also available.

Characteristics Comparison		Non Oriented Type	Biaxial Oriented Type	Polypropylene Laminated steel sheets	Polyethylene Laminated steel sheets
Sheathed resin melting point (heat resistance)		215 degree centigrade or higher	225 degree centigrade or higher	150 to 170 degree centigrade	100 to 130 degree centigrade
Chemical resistance	Acid	Good	Good	Good	Good
	Alkaline	Bad	Bad	Good	Good
	Organic solution	Good	Good	Good	Good
Electrolytic solution reaction		None	None	Absorbance	Absorbance
Sheathed resin uniaxial tensile elongation (90 degree centigrade)		Around 600%	Around 200%	-	-